Artist-D Unboxing checklist

Physical Printer Check

  • check wiring, nothing should be loose
  • Ribbon cables should be firmly set or they will burn up.
  • purge cups should not interfere with carriage motion


  • don’t mess with E2 leveling until E1 is perfect.
  • Remember leveling on this printer is center first, leveled with z stop ** then level corners with bed dials.


  • install latest firmware, the Twinkie community firmware is very popular

First Print

  • gcode should not be in sub folder on sdcard
  • if you’re inexperienced, work on single color prints with one extruder before adding idex

Calibrate Idex


Join us on discord!

Leave a Reply

Your email address will not be published. Required fields are marked *